The fully automatic anchor production line has been widely used in modern coal mining industrial production. It can automatically complete the anchor processing, greatly improving production efficiency and product quality. However, it is inevitable to encounter some common faults that affect the normal operation of the production line. Let's take a look at these faults and their solutions one by one.
1. The machine cannot start
This situation may be caused by a problem with the power supply. You should first check whether the power switch is normal, and then check whether the power cord is connected to the socket normally.
2. Excessive noise of the equipment
Excessive noise is often caused by wear of machine parts or loose bearings. The solution is to remove the part and replace the worn part or readjust the loose bearing.
3. The machine of the production line is stuck
If the machine is stuck and does not start, it may be because the machine parts are too compact or severely worn. You can try to remove the part for cleaning or replace the damaged part.
4. Cable failure
Damage to the wire may cause the equipment to not work or operate abnormally. To solve this problem, you can first check whether the wire connection point is correct, and then further check whether the condition of the wire is damaged.
5. Anchor rod irregularity
If the anchor rod is irregular after processing, it may be caused by tool wear or tool failure to adjust. The tool can be replaced or readjusted to solve the problem.
The above faults are common faults in the fully automatic anchor rod production line, but these faults can be well solved by inspecting, repairing or replacing parts of the equipment. In addition, during daily maintenance, pay attention to cleaning and lubrication, which can effectively reduce the occurrence of these faults and extend the service life of the equipment. Therefore, to ensure the long-term stable operation of the equipment, correct daily maintenance and timely maintenance are very important.